Power Enrichment Above Stoich FA Ratio
From SCT SRT Wiki
Under Section: Fuel
Name: Power Enrichment Above Stoich FA Ratio
Description:
This table is most commonly used to pull or add fuel to the map during WOT. This table will add or remove fuel from curve during conditions when the Air/Fuel Ratio of the car is above Stoich (14.7:1). I equate this table to a 'piggyback' fuel computer, where changing the values in this table will have a direct effect on the target AF curve during WOT.
Unlike a piggyback however, changing the values in this table does not have adverse effects on timing. The table does it's calculations based on the target Air/Fuel ratios you program in. If you have a modified car, the AFR's you program in might not be exactly or even close to what you want your REAL target AFR to be, so there will most likely be some experimentation by the tuner to reach their REAL target AFR on the dyno, also like a piggyback.
Values:
Y-Axis: Pressure Ratio (Ratio of Turbo Outlet Pressure to Turbo Inlet Pressure)
X-Axis: RPM
Notes:
F/A differs from A/F, but has the same result in the end. Your F/A ratio can be determined by dividing 1 by your A/F.
Example:
Stoich AFR to FA: 1/14.38 = 0.0695 (based on factory PCM value of 14.38:1 AFR)
Target AFR = 1/11.79 = 0.0848
Calculation:
Target_FA - Stoich_FA
0.0848 - 0.0695 = 0.0153
The value 0.0153 should be Input to the cells you want to attain the target AFR, in this case it was 11.79:1.
- To help the tuner better calculate this value, I have created a [1] calculator to aid.
Based on the screen shot below: For the cells that you wish to have an Air Fuel Ratio of 11.79:1 input the value 0.0153.
Use:
Used to for adding fuel when your A/F is over Stoich.
Related Tables:
Screenshot: This is for a stock map
